Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 1129 / 2086

44-33
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 44 Configuring Quality of Service
Configuring VSS QoS
To configure class-level queue-limit in a service policy, perform this task:
To remove the explicit queue size use the no queue-limit command under the class in a policy-map.
This example shows how to configure a class-based queue with an explicit queue-limit command. It
limits traffic class class1 to a queue of size 4048:
Switch# configure terminal
Switch(config)# policy-map policy1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# shape average 256000
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# policy-map
policy-map-name
Creates a policy map by entering the policy-map name, and enter
policy-map configuration mode.
By default, no policy maps are defined.
Step 3
Switch(config-pmap)# class class-name
Specifies the name of the class whose traffic policy you want to
create or change, and enter policy-map class configuration mode.
By default, no traffic classes are defined.
Step 4
Switch(config-pmap-class)# shape
average { cir-bps [ optional_postfix ] |
percent
percent }
Enables average-rate traffic shaping.
You can specify the shaping rate in absolute value or as a percentage:
• For cir-bps [ optional_postfix ] , specify the shaping rate in bps.
Range is 32000 to 10000000000 bps. Supply an optional postfix
(K, M, G).
•
For percent , specify the percentage of link rate to shape the class
of traffic. The range is 1 to 100.
By default, average-rate traffic shaping is disabled.
Step 5
Switch(config-pmap-class)# queue-limit
number-of-packets
Provides an explicit queue size in packets. The size must be a
multiple of 8 and ranging from 16 to 8184.
Step 6
Switch(config-pmap-class)# exit
Returns to policy-map configuration mode.
Step 7
Switch(config-pmap)# exit
Returns to global configuration mode.
Step 8
Switch(config)#
interface
interface-id Specifies a physical port and enter interface configuration mode.
Step 9
Switch(config-interface)#
service-policy output policy-map-name
Specifies the policy-map name, and apply it a physical interface.
Step 10
Switch(config-interface)# end
Returns to privileged EXEC mode.
Step 11
Switch# show policy-map
[ policy-map-name [class
class-map-name ]]
or
Switch# show policy-map interface
interface-id
Verifies your entries.
Step 12
Switch# copy running-config
startup-config
(Optional) Saves your entries in the configuration file.