Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 390 / 2086

7-34
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.0E and IOS 15.2(5)E
Chapter 7 Configuring the Cisco IOS In-Service Software Upgrade Process
Performing the ISSU Process
Pre-ISSU (Original) Image = N/A
Post-ISSU (Targeted) Image = N/A
Slot = 6
RP State = Standby
ISSU State = Init
Changeversion = TRUE
Operating Mode = Stateful Switchover
Current Image = bootflash:x.bin
Pre-ISSU (Original) Image = N/A
Post-ISSU (Targeted) Image = N/A
Aborting a Software Upgrade During ISSU
You can abort the ISSU process at any stage manually (prior to entering the issu commitversion
command) by entering the issu abortversion command. The ISSU process also aborts on its own if the
software detects a failure.
Note If you enter the issu abortversion command before the standby supervisor engine becomes hot, the
traffic might be disrupted.
If you abort the process after you enter the issu loadversion command, the standby supervisor engine is
reset and reloaded with the original software.
If the process is aborted after you enter either the issu runversion or issu acceptversion command, then
a second switchover is performed to the new standby supervisor engine that is still running the original
software version. The supervisor engine that had been running the new software is reset and reloaded
with the original software version.
Note
Ensure that the standby supervisor engine is fully booted before entering the abortversion command on
an active supervisor engine.
The following task describes how to abort the ISSU process before you complete the ISSU process with
the
issu commitversion command.
Perform the following task on the active supervisor engine:
This example shows how to abort the ISSU process on slot number 2, the slot for the current active
supervisor engine:
Switch> enable
Switch# issu abortversion 2
Command or Action Purpose
Step 1
Switch> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
Switch# issu abortversion active slot
[active-image-new]
Cancels the ISSU upgrade or downgrade process in
progress and restores the router to its state before the
process had started.