Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 1860 / 2086

75-10
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 75 Configuring Ethernet OAM and CFM
Configuring Ethernet CFM
Step 14
sender-id
{
chassis
|
none
}
(Optional) Include the sender ID TLVs, attributes
containing type, length, and values for neighbor devices.
•
chassis —Send the chassis ID (host name).
• none —Do not include information in the sender ID.
Step 15
mip auto-create [ lower-mep-only | none ] (Optional) Configure auto creation of MIPs for the service.
•
lower-mep-only —Create a MIP only if there is a MEP
for the service in another domain at the next lower
active level.
• none —No MIP auto-create.
Step 16
exit
Return to ethernet-cfm configuration mode.
Step 17
mip auto-create
[
lower-mep-only
]
(Optional) Configure auto creation of MIPs for the domain.
• lower-mep-only —Create a MIP only if there is a MEP
for the service in another domain at the next lower
active level.
Step 18
mep archive-hold-time minutes
(Optional) Set the number of minutes that data from a
missing maintenance end point is kept before it is purged.
The range is 1 to 65535; the default is 100 minutes.
Step 19
exit
Return to global configuration mode.
Step 20
interface interface-id
Specify an interface to configure, and enter interface
configuration mode.
Step 21
switchport mode trunk (Optional) Configure the port as a trunk port.
Step 22
ethernet cfm mip level level-id
(Optional) Configure a customer level or service-provider
level maintenance intermediate point (MIP) for the
interface. The MIP level range is 0 to 7.
Note
This step is not required if you have entered the
ethernet cfm mip auto-create global
configuration command or the mip auto-create
ethernet-cfm or ethernet-cfm-srv configuration
mode.
Step 23
ethernet cfm mep domain domain-name mpid
identifier
{
vlan vlan-id
|
port }
Configure maintenance end points for the domain, and
enter ethernet cfm mep mode.
•
domain domain-name —Specify the name of the
created domain.
• mpid identifier —Enter a maintenance end point
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to 8191.
•
vlan vlan-id —Enter the service provider VLAN ID or
IDs as a VLAN-ID (1 to 4094), a range of VLAN-IDs
separated by a hyphen, or a series of VLAN IDs
separated by comma.
• port —Configure port MEP.
Step 24
cos value
(Optional) Specify the class of service (CoS) value to be
sent with the messages. The range is 0 to 7.
Command Purpose