Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 154 / 2086

3-10
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 3 Configuring the Switch for the First Time
Configuring the Switch
<...output truncated...>
!
line con 0
transport input none
line vty 0 4
exec-timeout 0 0
password lab
login
transport input lat pad dsipcon mop telnet rlogin udptn nasi
!
end
Switch#
Saving the Running Configuration Settings to Your Start-Up File
Caution This command saves the configuration settings that you created in configuration mode. If you fail to do
this step, your configuration is lost the next time you reload the system.
To store the configuration, changes to the configuration, or changes to the startup configuration in
NVRAM, enter the
copy running-config startup-config command at the enable prompt (#), as follows:
Switch# copy running-config startup-config
Reviewing the Configuration in NVRAM
To display information stored in NVRAM, enter the show startup-config EXEC command.
The following example shows a typical system configuration:
Switch# show startup-config
Using 1579 out of 491500 bytes, uncompressed size = 7372 bytes
Uncompressed configuration from 1579 bytes to 7372 bytes
!
version 12.1
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
service compress-config
!
hostname Switch
!
!
ip subnet-zero
!
!
!
!
interface GigabitEthernet1/1
no snmp trap link-status
!
interface GigabitEthernet1/2
no snmp trap link-status
!
--More--
<...output truncated...>