Circontrol Raption 50 Series, User Manual

Page: 94 / 168

90
Raption 50 Series User Manual
NOTE
: When the LEDs are cycling yellow, the reset button has been pushed and the
device is restarting.
Power LED
This monitors the input power or shows if the device sees a GPS signal.
•
Off:
No power or input voltage ≥ 36VDC or ≤ 7.5VDC.
•
Red:
The device is not operational (failure or in low power mode)
•
Yellow:
The device is entering low power mode or system low level boot.
•
Green:
The device is connected to nominal power and is operating normally.
•
Green with a momentary yellow flash:
The device has a GPS fix.
Activity LED
This shows the radio’s activity.
•
Off:
The LED’s normal appearance.
•
Flashing green:
The radio is transmitting or receiving.
Signal LED
This shows the cellular network’s signal level.
•
Flashing red:
No signal is present. (RSSI > -110 dBm)
•
Red:
A bad signal is present. (RSSI > -100 dBm or ≤ -110 dBm)
•
Yellow:
A marginal signal is present. (RSSI > -85 dBm or ≤ -100 dBm)
•
Green:
A good signal is present. (RSSI ≤ -85 dBm)