Christie Roadie 25K, User Manual

Page: 65 / 191

OPERATION
Roadie 25K User’s Manual
3-9
Channel
Press to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
), the display will automatically change and update
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust animage from a new source.
NOTE:
Chan
key behavior during a presentation depends on whether or not the
Display Channel List option is enabled in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
Chan
, or you may prefer to
enter the desired channel number “blind”, i.e., without on-screen feedback. See
Menu Preferences later in this section.
Input 1
Press
Input 1
to display from the data input source connected to BNCs labeled
INPUT 1
.
If PIP is enabled, pressing this key will change the PIP source.
Input 2
Press
Input 2
to display from the DVI source (analog or digital) connected to
INPUT 2
. If
PIP is enabled, pressing this key will change the PIP source.
Input 3
Press
Input 3
to display from the composite video source connected to
INPUT 3
. If PIP is
enabled, pressing this key will change the PIP source.
Input 4
Press
Input 4
to display from the S-video source connected to
INPUT 4
. If PIP is
enabled, pressing this key will change the PIP source.
Input 5
Press
Input 5
to display from the
INPUT 5
interface module installed in the Option 1 slot,
which is typically the standard factory-installed Dual SD/HD-SDI Module. If PIP is
enabled, pressing this key will change the PIP source.Note that if there are two inputs
connected to this module, the second input (B) is considered
INPUT 7
and can be most
easily accessed with
Input
. Or, if you are using the built-in keypad or the optional
“lite” remote keypad, neither of which have a separate
Input
key, use
INPUT 5
to
access
INPUT 7
as follows:
•
While displaying from
INPUT 5
, press
Input 5
again. This switches to
INPUT 7
.
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press
Input 5
. This switches to either
INPUT 5
or
INPUT 7
, depending on which of
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
Input 5
again
to display from the other Dual SD/HD-SDI Module input.
Input 6
Press
Input 6
to display from the
INPUT 6
interface module installed in the Option 2 slot.
If PIP is enabled, pressing this key will change the PIP source. If the Dual SD/HD-
SDI Module is installed here, and there are two inputs connected, its second input (B)
is considered
INPUT 8
and can be most easily accessed with
Input
. Or, if you are
Chan
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6