Christie Roadie 25K, User Manual

Page: 23 / 191

INSTALLATION AND SETUP
Roadie 25K User’s Manual
2-17
install a lens plug. 2) Always re-install a lens in its previous “UP” orientation,
otherwise boresight may require re-adjustment.
Lens Stabilizer
Install the lens stabilizer at the lens mount as described in
the Lens Mount Anti-Vibration Upgrade instructions
provided with the projector. This small bracket will help
stabilize the lens within the mount to minimize vibration in
projected images. It is packaged with other accessories such
as the remote keypad, Roadie 25K User’s Manual, etc.
Anamorphic Lens Installation
(OPTIONAL)
NOTE: The optional anamorphic lens mount is required for use of the 1.25x
anamorphic lens, producing 2.39:1“scope” images.
If the anamorphic lens will be used, it is recommended that you add the lens—and its
mount—before final leveling, boresight adjustment and the like. Install only for those
installations requiring full-size 2.39:1 “scope” display (mostly side-masking screens)
obtained by optically stretching a pre-squeezed image.
1.
INSTALL THE ANAMORPHIC LENS MOUNT ON THE PROJECTOR:
At the front
of the projector, install the anamorphic lens mount hardware as described in
the instructions provided with Christie’s Anamorphic Lens Mount Kit.
2.
INSTALL THE 1:25x ANAMORPHIC LENS:
Clamp the 1.25x anamorphic lens
mount in place, following the instructions provided with the anamorphic lens
mount kit.
WARNING
Protective gear required.
Qualified service technician required.
Remove the lamp door and open the empty lamp cooling compartment.
Figure 2.19. Open Lamp Door and Cooling Compartment
Install one of the following lamps in the projection head, depending on your model
and site:
Single-or-3-Phase Ballast 3-Phase Ballast Required
2.0 kW * 4.5 kW **
3.0 kW ** 6.0 kW **
* For this projector, the 2.0 kW is available in CDXL (maximum performance) only
** Available as CDXL (maximum performance) or original CXL (less expensive).
Refer to full specifications in Section 6.
Install First Lamp
'