Christie Roadie 25K, User Manual

Page: 50 / 191

INSTALLATION AND SETUP
2-44
Roadie 25K User’s Manual
3. Adjust the horizontal boresight bolt
(Figure 2.47) as necessary to direct or
“aim” the lens toward the side of the
image which focused too close to the
lens. When both sides appear equally
blurry, re-focus on the left side of the
screen.
4. Adjust horizontal offset to re-center the
image on the screen.
5. Repeat Steps 4 and 5 until both sides of
the are well-focused.
6. Adjust the “hold” screw to lock in
place, and check boresight again.
7. When the left/right
boresighting is complete,
focus the image at the
top edge of the screen
(Figure 2.48).
If the bottom remains
blurry while the top edge
is focused, refer back to
Step 2 but use a paper at
the bottom of the screen
to determine whether the
bottom of the image is
focused in front of the
screen or behind the screen. If the bottom is well-focused, skip to Step 11.
8. Adjust the vertical boresight bolt (Figure
2.49) using one allen key to hold the bottom
hex screw and another to turn the adjustment
bolt above it. Adjust as necessary to direct or
“aim” the lens toward the edge of the image
which focused too close to the lens. When
both top and bottom appear equally blurry, re-
focus at the top of the screen.
9. Adjust vertical offset to re-center the image
on the screen.
10. Repeat steps 8 and 9 until the top and
bottom of screen are both well-focused.
11.
REFOCUS
: Although all sides of the image
should now be in focus, the center of the
image will be slightly blurry at this point.
Refocus at center of image. The goal is good focus at center and on all sides.
12. Adjust the “hold” screw to lock in place, and check boresight again.
Figure 2.47. Adjust
L/R Boresight
Figure 2.48. Adjust Top Focus
Adjust Top/Bottom
'
Boresight
Figure 2.49. Adjust Top/Bottom
Boresight