Christie Roadie 25K, User Manual

Page: 149 / 191

SPECIFICATIONS
Roadie 25K User’s Manual
6-3
DVI-I
(INPUT 2)
Interface standard DDWG DVI 1.0
Signal types / color spaces
•
RGB (digital or analog)
•
YPbPr (analog)
•
YCbCr (digital)
not supported in v1.1 s/w
Pixel clock rate 25 – 165 MHz
Analog sync input impedance 1 k
S
Maximum cable length 5 meters (16 ft.)
Supports EDID and HDCP
For all other DVI specifications,
see Analog: RGB / YPbPr
on previous page.
Dual SD/HD-SDI
(INPUT 5 or 6, STANDARD WITH PROJECTOR)
Number of inputs 2, each with active loop-through
Connector type BNCs, 75
S
Supported interface standards SMPTE 259M
(13.5 MHz clock modes only)
SMPTE 292M
Signal types / color spaces Serial digital YCbCr
(4:2:2 only)
Pixel clock rates supported 13.5 MHz, 74.25 MHz, 74.25/1.001 MHz
Wired Remote Keypad
(CONVERTED FROM IR REMOTE KEYPAD)
2 inputs on projection head • 3-pin XLR connector (rear)
• 3.5mm phono jack (side)
Input levels • High = 2.2 V – 5.6 V (or open)
• Low = -0.6V – 0.9V @ 1mA
Voltage output +5VDC ±5%
Current output 100 mA nominal, 250 mA max.
Cable length 25 ft.
IR Remote Keypad
Number of IR sensors on projector 2 (front and rear)
Wavelength of peak sensitivity 950 nm
Modulation (carrier) frequency 36 kHz (nominal)
Encoding method bi-phase
Range 100 ft.
Assumes no fluorescent lighting interference.
If range appears limited, shield the IR sensor, turn off lights, or change your fluorescent ballast.
Ethernet
Number of ports 1
Standard 100Base-TX
Connector type RJ-45
Max. baud rate 115200
RS232 Serial Input
Number of connectors 2
Connector type 9-pin subminiature D (female=in,
male=out)
Max. baud rate 115200
Control
'