Cantel Medical MEDIVATORS DSD EDGE, Service Manual

Page: 94 / 152

94
Process Interruption
A process interruption may occur due to a system interruption, or initiated by the operator.
System Interruption
A system interruption may be caused by loss of water or air, loss of power, or by a lack of available Part A and Part B
disinfectant components.
Note: During an operating cycle, reprocessors with optional lid locks cannot be opened
except by means of a service code.
1. Correct the error, then press the START button.
- The reprocessor continues the cycle from the point of interruption.
- If the interruption is caused by a power outage, the reprocessor automatically restarts the cycle when power
is restored. A “Power On” message will be indicated in the log.
Operator Initiated Interruption
1. Press the STATION SELECT button to choose station A or station B.
2. Terminate Cycle: Press the CANCEL button, then the ENTER button. The present cycle is aborted. The reprocessor
fails to a safe mode and the endoscope must be reprocessed.
- If the cycle is terminated, an “Aborted” message will be displayed. The endoscope should not be used unless
a “Cycle Completed” message is displayed.
Service: If the error recurs, or cannot be corrected, refer to the Troubleshooting chapter.
3. Interrupt Cycle: Press the STATION SELECT button, then the STOP button.
- To resume the cycle press the START button. The cycle proceeds as normal.