87
Wash Phase
The wash phase consists of up to two Soak segments. The operator has the choice to run one wash segment, two wash
segments or no wash segments. Setting the Soak time above zero using Setup 5, disables the second segment.
Note: If one or
two wash segments are chosen, then the flush phase is skipped.
During Soak, the detergent is injected into the basin through the scope channels according to the programmed detergent
injection time. The default detergent injection time is 3 seconds (~9ml). Please refer to the table in the Programming the
Reprocessor section for the appropriate dilution and timing settings. After injection, water fills the basin and the endoscope
is soaked in the basin for the programmed soak time. The basin is then drained while the endoscope channels are flushed
with fresh water. A Rinse Soak period then follows which is identical to the soak period. However, no detergent is injected
during this time.
Summary of Contents for MEDIVATORS DSD EDGE
