Cantel Medical MEDIVATORS DSD EDGE, Service Manual

Page: 88 / 152

88
Air Phase
The Air phase is simply a programmed time during which air is purged through the endoscope channels.
Note: Please refer to the Disinfection Cycle Chart for user programmable time settings, default
state times, and time limitations.
Note: Every drain transaction is followed by an air purge where air is flushed through the
endoscope channels and internal fluid lines. The Air LED on the control panel blinks during air
purge.
Note: During each phase of the cycle, an LED illuminates to indicate the present phase. The Flush
LED indicates that one of the wash phase segments is running.
Pre-start Inspection
Use the following procedure to inspect the reprocessor before startup.
1 Check the external pre-filters if installed on the incoming water supply. Replace any filters if the dynamic
pressure drop across any filter is greater than 10 psi. Inspect the pressure gauges for pressure reading when water
is flowing through the filters.
2 Check the detergent reservoir (if utilized) for proper detergent level. Add detergent, if necessary.
3 Check the alcohol reservoir (if utilized) for proper alcohol level. Add alcohol, if necessary.
CAUTION!
For the alcohol and detergent bottles; remove, refill and replace each bottle
(alcohol and detergent) separately to ensure the correct fluid is in reservoir.
!