Canon MultiPASS C530, User Manual, Page: 66 / 383

■
If your printed page contains a large amount of graphics, the ink on the page may be
damp due to the print density. Leave the page in the output tray for 30 to 60 seconds to
allow the ink to dry. Then remove the page being careful not to touch the document tray
(if it is open). Should you dirty the document tray when removing the page, wipe it clean
with a clean, soft, lint-free cloth moistened with water or diluted dishwashing detergent
solution.
■
The capacity of the paper output tray is 50 sheets of paper. To reduce paper jams, remove
paper from the output tray before the count reaches 50.
■
If paper curls after printing, remove it immediately; otherwise paper jams may occur.
■
The platen (a roller on the inside of the unit) may become inked if you print data beyond
the width of the page. If this happens, clean the platen with a soft cloth (see
page 7-8 ).
■
Let the paper run out before you refill the multi-purpose tray. Avoid mixing “new” paper
with paper remaining in the tray.
■
Use cut-sheet paper only, not paper that comes on a roll.
■
Do not use paper that is thicker than specified for the MultiPASS. Printing with paper
that is thick enough to come in contact with the print head nozzles may damage the
BJ cartridge.
■
Store paper and other media on a flat surface, and leave it in its wrapper until you are
ready to use it. Store unused paper from opened packs in the original packing in a cool,
dry location.
■
Store paper at 64.4°–75.2°F (18°–24°C), 40%–60% relative humidity.
Chapter 2 Paper Handling
2-16