Canon iR4570 Series, Service Manual

Page: 806 / 876

Chapter 16
16-46
16.5 FUNCTION
（
Operation/Inspection Mode
）
16.5.1 COPIER
16.5.1.1 Copier List
0007-9317
iR2270 / iR2870 / iR3570 / iR4570
<INSTALL>
T-16-31
COPIER > FUNCTION > INSTALL
Sub-item Description Level
TONER-
S
Stirring toner in the developer at installation
1
<Operating procedure>
1. Select an item to reverse its display.
2. "Check the Developer" is displayed.
Check that the developer connector is connected.
3. Press the OK key to start operation. The operation automatically stops
after count-down.
<Reference>
"Check the Developer" is displayed to prevent the connector from being
disconnected when the developer is replaced. Therefore, this message is
not necessary when the machine is shipped with the developer for
installation.
STRD-
POS
Automatically adjusting the CCD read position at flow read
- This is necessary when DF is installed and when ADF is removed and
mounted again.
1
<Operating procedure>
1) Select an item to reverse its display. Then press the OK key.
- Adjustment automatically starts and stops.
2) Since the value is updated in the service mode,
COPIER>ADJUST>ADJ-XY>STRD-POSenter the value into the service
label.
CARD Installing and setting the card reader
1
<Operating procedure>
Enter the card number (1 to 2001) and press the OK key. (One thousand
cards can be used from the input card number.)
Then the card management information (department ID and PIN) is
initialized.
E-RDS for future expansion 1