Canon iR C1020 Series, Service Manual

Page: 338 / 408

Chapter 17
17-2
17.1.3 Menu List
0020-4718
T-17-1
Maintenance
code
Special management function
Applicable
mode
Setting value
(*default)
Control details
27767 High-resisting paper mode All modes OFF *
ON
Lower the final output value of transfer bias by 250V.
(Only if the high-humidity transparency mode or high-humidity glossy film
mode is not specified.)
27267 4mil transparency mode Transparency OFF *
ON
Lower the final output value of transfer bias by 500V.
(Only if the high-humidity transparency mode, high-humidity glossy paper
mode or high-resisting paper mode is not specified.)
23866 Calcareous paper mode All modes OFF *
ON
Apply the maximum attraction bias regardless of environment. Since there is
no attraction paper resistor result, set the transfer bias in accordance with the
environment.
25407 Thin/rough paper mode Thin paper OFF *
ON
Change the process speed by 4/5 speed. Use the temperature control table for
thin/rough paper (for thin paper only).
Process speed is not changed but the temperature control table is changed (for
plain or thick paper 2 only).
47267 High-humidity transparency mode Transparency OFF *
ON
Lower the final output value of transfer bias by 100V (for transparency only).
47667 Re-transfer prevention mode All modes OFF *
ON
Lower the transfer bias of yellow and black according to the environment.
(Only if the high-humidity transparency mode, high-humidity glossy film
mode, high-resisting paper mode or 4mil transparency mode is not specified.)
34691 Color displacement correction
mode Color mode OFF *
ON
Pre-rotation is extended by 10 sec and also paper interval is extended by one
and half-round when printing.
14682 Foggy image prevention mode All modes OFF *
ON
Pre-exposure is turned OFF. Transfer bias is not applied as a countermeasure
against the trailing edge toner splash.
25200 Transparency permeability
correction mode Transparency OFF *
ON
Specify the control temperature at 180 deg C and make an idle rotation of the
fixing assembly for 45 sec at initial rotation.
53649 Monochrome mode engage mode Monochrome
mode
OFF *
ON
Print in ETB full-engaged mode.
35607 Hot offset prevention mode All modes OFF *
ON
Lower the control temperature by 10 deg C without exception.
14660 Monochrome printer mode Monochrome
mode OFF *
ON
Print all data in monochrome mode.
65676 Leading edge margin switch
(enlarge) All modes OFF *
ON
Enlarge the leading edge margin by 2 mm. When the leading edge margin is
already set to small beforehand, the margin will be standard.
65677 Leading edge margin switch
(reduce) All modes OFF *
ON
Reduce the leading edge margin by 2 mm. When the leading edge margin is
already set to large beforehand, the margin will be standard.
68676 Image position correction mode
(toward right) All modes OFF *
ON
Use this when the image is displaced to the left. When this is specified, image
is moved to the right by 2 mm. When the image position correction mode
(toward left) is already set, margin will be standard.
68677 Image position correction mode
(toward left) All modes OFF *
ON
Use this when the image is displaced to the right. When this is specified, image
is moved to the left by 2 mm. When the image position correction mode
(toward right) is already set, margin will be standard.
25607 Printing mode setting switch For overseas
models (plain
paper mode) OFF *
ON
To prevent hot offset at outside Japan, change the printing mode of [plain
paper] from [Normal mode] to [Light mode].