Canon imageRUNNER 5570, Network Manual

Page: 211 / 274

Network Connection Problems and Remedies 8-3
8
T
roub
lesho
o
ting
Remedy Check the following:
•
If the dial-up router does not have to send packets via broadcast, change the
router settings to ensure that it sends packets via a method other than
broadcast. If dial-up router has to send packets via broadcast, check that the
settings are correct.
•
Check that the file or mail server's host name or IP address set on the
machine is correct.
•
If you attempt to access a device on the network to which the machine is
connected, with the DNS server on an external network, set the destination
using an IP address, not a host name.
•
If information about a device on an external network is set on the DNS server
on the network to which the machine is connected, check the settings.
Detailed information concerning the machine cannot be set or browsed using the Remote UI
or utility.
Cause 1 The IP addresses of computers on which the Remote UI or utility is used are not
allowed in <Setting/Browsing Range> in [IP Address Range Settings].
Remedy If the settings for <Setting/Browsing Range> in [IP Address Range Settings] do
not permit the IP address of a computer on which the Remote UI or utility is
used, you cannot set the machine setting items or browse information on the
machine.
Check the settings for <Setting/Browsing Range> in [IP Address Range
Settings]. (See step 22 in "TCP/IP Settings," on p. 3-4.)
Cause 2 [Use SNMP] or [Enable Dedicated Port Settings] is set to 'Off'.
Remedy Set [Use SNMP] and [Enable Dedicated Port Settings] to 'On'. (See
"Communication Environment Setup," on p. 2-13.)
Cause 3 The SNMP community name does not match.
Remedy If you use an SNMP community name different from the one stored in the
machine to access the machine from a utility, the utility will not detect the
machine. In this case, check the SNMP community name. (See
"Communication Environment Setup," on p. 2-13.)