Canon CLC 5000, Service Manual

Page: 319 / 757

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
CHAPTER 3 INSTALLATION
3-18
Step Work Remarks
F03-203-12
16 Put the process unit back into the
machine, and remove the grips.
17 Install the two screws removed in step
12.
18 Install the photosensitive drum
positioning knob.
19 Install the primary charging assembly.
(Be sure to put each charging assembly
back to its original location.)
20 Slide out the transfer unit, and remove
the drum protection sheet in the direction
of the arrow.
Store away the drum protection sheet.
Do not touch its areas that will
come into contact with the
drum.
To store, put it in a plastic bag,
and keep it protected from dust
and oil.
If it must be rolled, be sure that
the side that will come into
contact with the drum is inside.
21 Install the transfer unit cover, and put
the transfer unit back into position;
then, set (lock) the lever of the transfer
unit.
22 Release the lock to the lower left of the
hopper; then, bring down the hopper
assembly to the bottom to set it in
position.
23 Insert the cover switch actuator into the
cover switch assembly.
24 Check the power supply, and connect the
power plug. Turn on the power switch,
insert the control key, and turn it.
Drum protection sheet
Drum protection sheet