Cabletron Systems Netlink FRX4000, User Manual

Page: 193 / 426

Configuring BSC Batch 11-7
NAK Retry Count
specifies the number of times the node will send a frame when the receiving device is
unable to acknowledge; that is, returns a NAK to the node.
VC to be Cleared After Disc
specifies whether the virtual circuit will be cleared after completion of a file transfer.
Idle Timer
is activated on reception of an EOT from the line. On expiry, an EOT is sent to the line
and a Clear Request is sent if
VC to Be Cleared After Disc
is
Y
.
Subscriber Parameters
Sq
is simply a line number to ease selection of a line on the screen to change. To move to
another line, press
[A]
and enter the sequence number.
Local Sub
is the calling address used by the local device. A Subscriber ID (see page 11-8 ) must
also be configured for this address.
Remote Sub
is the called address used for calls by the local device. A Subscriber ID (see page 11-
8 ) must also be configured for this address.
If the BSC port is one end of a connection to a logical X.25 port in the FRX4000/6000,
this address must match a Subscriber ID configured for the logical port.
Atcl
(Autocall) causes a BSC device to automatically the remote end when it becomes
active.
Rtytm
is the Retry Timer, which determines the time between autocall retries.
Rty#
is the maximum number of times an autocall will be sent. Note that a value of
0
allows
indefinite retries.
Del
lets you delete the remote subscriber that is currently highlighted. You will be
prompted:
Delete "n,"
where
"n"
is the sequence number. Pressing
[Y]
will delete that
line and move all entries below it up one sequence number.