Cabletron Systems MMAC-Plus SFCS-1000, Configuration Manual

Page: 283 / 404

B-131
AMI Configuration Commands
B.16.3 Displaying UNI 3.0 Signalling Paths
This command allows the user to list an individual switch fabric’s current
UNI 3.0 signalling path information. Enter the following parameters:
localhost::configuration uni30>
show
Port VPI State ILMI UNIside Type OperType RemoteAddress
1C1 0 down down network auto privateUNI
1C2 0 down down network auto privateUNI
1C3 0 down down network auto privateUNI
1C4 0 down up network auto privateUNI 169.144.64.108
1D2 0 down down network auto privateUNI
1D3 0 down down network auto privateUNI
1D4 0 down down network auto privateUNI
1CTL 0 up down network auto privateUNI
The fields in this display have the following meaning:
Port Indicates the port number of the network modules
that are currently installed in the switch. The 1 indi-
cates that it is the first switch fabric. The letter indi-
cates the position of the network module in the
switch. The 1, 2, 3, 4 indicate the specific port num-
ber. CTL indicates the control port which is a logical
(not physical) location where cells that are directed to
the switch itself are sent.
VPI Shows the UNI 3.0 signalling path.
State Shows the current state of the port. If the state is up ,
then this port is functional. This is the normal state
for a port that is connected to another Cabletron Sys-
tems’ ATM switch or host. If the state is
down , then
this port is not functional. This can be due to a lack of
a physical connection or due to a software problem.
ILMI Up means that ILMI NSAP registration is enabled for
this port (only when a host is connected). Down
means that ILMI NSAP registration is not enabled for
this port.
UNIside Indicates the switch user side or network side. If the
connection is to a host,
network is displayed. If the
connection is to another switch, one switch must be
user and the other switch must be network .