Cabletron Systems MMAC-Plus SFCS-1000, Configuration Manual

Page: 237 / 404

B-85
AMI Configuration Commands
B.8.9 TAXI Port Configuration Commands
These commands allow the user to modify various aspects of the configura-
tion of all of the ports on a TAXI network module. The following TAXI com-
mands are available only when a TAXI network module is installed in the
switch fabric. The user can display the list of available subcommands by typ-
ing
taxi ? at the port level.
localhost::configuration port>
taxi ?
loopback show
B.8.9.1 Configuring TAXI Port Loopback
This command allows the user to designate the type of loopback on a port on
a TAXI network module. Enter the following parameters:
localhost::configuration port taxi>
loopback <port> (diag | none)
port Indicates the port number on which the loopback
mode is to be changed.
diag Choosing diagnostic loopback connects the receiver
to the transmitter. The TAXI stream transmitted by
the fiber to a port is looped back to the fiber. The
stream is still transmitted over the fiber, but the
incoming stream is ignored.
none Selecting none designates that no loopback will take
place. This is the default setting.