Cabletron Systems MMAC-Plus SFCS-1000, Configuration Manual

Page: 249 / 404

B-97
AMI Configuration Commands
B.10.2.2 Creating an SNMP Trap Entry
This command allows the user to specify a host to which a switch can send
SNMP traps. The SNMP traps supported by this switch are detailed in the
FORE-Switch-MIB. Enter the IP address of the SNMP trap destination to be
added. Repeat this for as many SNMP trap destinations as needed. Traps are
active as soon as they are set. Enter the following parameters:
localhost::configuration snmp trap>
new <ipaddress>
ipaddress Indicates the IP address of the trap destination to be
created.
B.10.2.2.1 Displaying the SNMP Trap Entries
This command enables the user to list all of the current SNMP traps. The
SNMP traps supported by this switch are detailed in the FORE-Switch-MIB.
Enter the following parameters:
localhost::configuration snmp trap>
show
Trap Destination
1 192.88.243.18
2 198.29.16.14
3 198.29.16.18
4 198.29.23.39
5 198.29.31.130
If no SNMP traps have been configured, the following message is displayed:
No trap information is available