Cabletron Systems 9A656-04, Configuration Manual

Page: 140 / 172

Chapter 4: Signalling and Routing
Page 4-12 9A656-04/9A686-04 Configuration Guide
4.5.1 Signalling Configuration
The following two subsections provide instructions on configuring the IISP Signalling stacks
and sides of the applicable interface.
4.5.1.1 Step 1: Set the IISP Signalling Version and Type
The first step in configuring IISP is to assign which Signalling stack type the individual front
panel interface will use for the connection, (IISP UNI 3.0, 3.1, or 4.0). This is accomplished
using the atmIntfConfigType command. Refer to
Figure 4-4 .
Figure 4-4 Setting the Signalling Stack
Figure 4-4 contains 3 callouts that display status information, and the configuration fields
necessary to set the Signalling stack. The definitions for the callouts are as follows:
A
Displays the name of the MIB command used to perform this procedure (atmIntfConfigType)
and the OID string the SNMP application is using to access this information
(1.3.6.1.2.1.37.14.1.14.1.1).
A
B
C