F3/F3R OWNER’S MANUAL
- 200 -
Checking the engine oil level
With the engine arrives at operating
temperature, turn it off and check the oil
level with a dipstick.
1. To get a correct reading, the vehicle
should be on level ground. After turning
off the engine, wait a few minutes for the
oil to drain back into the bottom of the
engine.
2. Pull the oil dip rod out, hold a rag under
the end, and wipe it clean.
3. Reinsert the oil dip rod, and push it in as
far as it will go, or the reading will not be
correct.
4. Pull the oil dip rod out and look at the oil
level while placing a rag at the end.
NOTICE
Be careful not to drop the engine oil on
vehicle components.
If the oil level goes below or slightly above
the low level, fill the engine oil of the same
type into the engine.
Remove the oil filler cap and add the engine
oil in small quantities at a
time, and check the oil dip rod. We
recommend that you use a funnel when
adding oil.
To confirm the quantity of needed oil, please
take reference from the interval between the
low and high level on the oil dip rod.
When the level reaches within the correct
range, install the filler cap and tighten it by
hand.
NOTICE
●
Do not spill oil onto spare parts.
●
Avoid overfilling, or the engine
could be damaged.
●
Check the oil level on the dipstick
once again after adding the oil.
Oil type selection
Use the oil approved by BYD AUTO or
C
M
Y
CM
MY
CY
CMY
K
折手文档 1.pdf 1 2011-3-21 17:20:22
