Branson Krautkramer MIC 10, User Manual

Page: 47 / 146

Viewing measurement set and deleting
any measurement value
During the measurement you are able to view the ac-
tive measurement set. However, this only applies if
you have not yet closed the set with
-
.
0
Note:
With the DL version of the MIC 10 you have access to
measurements already stored. Refer to Chapter 5.2
Data storage .
Single measurement readings are displayed as well as
their total number, over-threshold condition of the read-
ing, absolute/relative standard deviation as well as the
active average reading. You have the possibility to di-
rectly select and delete a single reading. The average
reading is then reevaluated.
The basic procedure
You obtain this function via
.
; you select all the indi-
vidual steps after each other in the order described
below using
M
. If you interupt the function and wish to
continue your measurement, press
-
or carry out an-
other measurement.
The following status indication on the display flashes
with all steps of this function in order to indicate that
you have interupted the measurement and can con-
tinue:
Viewing the readings
–
Press
.
.
0
Note:
If MIC 10 DL is used and data storage is active the ac-
tual file number is displayed. Press
M
-key.
The previous number of readings appears on the dis-
play:
Example: 5 previous readings
–
Press
M
.
Hardness measurement
Operation
Krautkrämer MIC 10 Issue 08, 08/01 5-11
Viewing measurement set and deleting
any measurement value
During the measurement you are able to view the ac-
tive measurement set. However, this only applies if
you have not yet closed the set with
-
.
0
Note:
With the DL version of the MIC 10 you have access to
measurements already stored. Refer to Chapter 5.2
Data storage .
Single measurement readings are displayed as well as
their total number, over-threshold condition of the read-
ing, absolute/relative standard deviation as well as the
active average reading. You have the possibility to di-
rectly select and delete a single reading. The average
reading is then reevaluated.
The basic procedure
You obtain this function via
.
; you select all the indi-
vidual steps after each other in the order described
below using
M
. If you interupt the function and wish to
continue your measurement, press
-
or carry out an-
other measurement.
The following status indication on the display flashes
with all steps of this function in order to indicate that
you have interupted the measurement and can con-
tinue:
Viewing the readings
–
Press
.
.
0
Note:
If MIC 10 DL is used and data storage is active the ac-
tual file number is displayed. Press
M
-key.
The previous number of readings appears on the dis-
play:
Example: 5 previous readings
–
Press
M
.
Hardness measurement
Operation
Krautkrämer MIC 10 Issue 08, 08/01 5-11