Branson Krautkramer MIC 10, User Manual

Page: 46 / 146

–
Using
^
you can switch between single or average
value.
–
A measurement set is closed by pressing
-
.
If you are working with the DL version of the MIC 10,
the measurement set is now stored and the file name
displayed (refer to Chapter 5.2).
–
Press
-
to return to the MEASUREMENT level or
carry out a new measurement.
Deleting the last measurement reading
You can delete a critical single reading without interup-
ting the measurement set.
–
Press
+
.
The last reading flashes. It also appears on the display
if you have selected the average value display mode.
–
Press
+
again.
The reading is deleted. At the same time, the average
value is automatically reevaluated. This is displayed if
you have selected the average value mode.
You can repeat this sequence with the last reading
until all readings have been deleted.
Viewing the last average value
You can also recall the last calculated average value
after termination of a measurement set.
Due to the fact that the last settings always remain in
the instrument, the average value will also remain
within the scope of the calibration setting.
–
Press
M
.
The average value of the last measurement appears
on the display.
Operation
Hardness measurement
5-10 Issue 08, 08/01 Krautkrämer MIC 10
–
Using
^
you can switch between single or average
value.
–
A measurement set is closed by pressing
-
.
If you are working with the DL version of the MIC 10,
the measurement set is now stored and the file name
displayed (refer to Chapter 5.2).
–
Press
-
to return to the MEASUREMENT level or
carry out a new measurement.
Deleting the last measurement reading
You can delete a critical single reading without interup-
ting the measurement set.
–
Press
+
.
The last reading flashes. It also appears on the display
if you have selected the average value display mode.
–
Press
+
again.
The reading is deleted. At the same time, the average
value is automatically reevaluated. This is displayed if
you have selected the average value mode.
You can repeat this sequence with the last reading
until all readings have been deleted.
Viewing the last average value
You can also recall the last calculated average value
after termination of a measurement set.
Due to the fact that the last settings always remain in
the instrument, the average value will also remain
within the scope of the calibration setting.
–
Press
M
.
The average value of the last measurement appears
on the display.
Operation
Hardness measurement
5-10 Issue 08, 08/01 Krautkrämer MIC 10