Belarus 1025/1025.2/1025.3
Рsection F. Ganging up
F22
a)
b)
Diagram of filling wheel tires with fluid (a) and removing fluid from tires (b):
1 – tip; 2- hose; 3- reservoir; 4- coupling nut; 5- lock screw; 6-sealing; 7-valve; 8-
pipe.
Observe the following sequence of filling tires
with liquid ballast:
1. let air out of the inner tube, then
disconnect tip (1)of the fixture with
valve casing by means of coupling nut
(4);
2. connect the hose end (2) of the
fixture to tank (3) with liquid, placed at
least 1.5 m above the wheel;
3. Jack up wheels;
4.
Open valve with liquid and fill the inner
tube with liquid up to required level, from
time to time shutting down access of
liquid inside tube and releasing air by
way of stop screw. Fill tube with liquid
until fixture tip comes out of it through
unscrewed stop screw;
5. disconnect the fixture from tank
valve casing;
6. drain extra liquid, then put metal
bushing with cup and control valve
inside the valve;
7. remove cup from valve and bring
pressure in tires to norm;
8. put cup on the valve and lower the
wheel.
Inner tubes may also be filled by means
of pressure pump , or via fixture hose ,
connected to water supply pipe..
WARNING: With liquid inside tubes,
check pressure in tires only with valve in
topmost position to avoid liquid
damaging air pressure indicator.
150
0 m
m
Summary of Contents for 1025 2008
Page 205: ......