Belarus 1025/1025.2/1025.3
Section F. Ganging up
F26
Conditions of safe ganging up
To ensure safe and reliable tractor
operation follow recommendations
providing for stability, allowable loads
on axles and tires at different
movement speed and air pressure in
them.
Load on the front axle should always
(with hinged implement or without it)
be at least 20% (0.2) of operation
tractor mass itself. Otherwise the
tractor will not be stable enough in
steering.
ATTENTION!
1. Load on tires, as well as type and
mass of ballast can be determined only
by weighting. When purpose of use
changes, always correct ballast mass
and air pressure in tires.
2. Values of limit and intermediate
loads on tractor tires, as well as values
of relative inside pressure, are set by
the manufacturer of tires and given in
the table.
3. To determine value of load on tires
use the following method of tractor
weighting:
- Front axle is weighted (with machines
lowered down);
- Rear axle is weighted (with lifted
machines);
- The concrete value of mass part on
the wheel is estimated by dividing by half
(by two), of the weighted value,
correspondingly, front or rear axle.
ATTENTION!
During operations with large torque
(ploughing, etc.) observe
recommendations valid for 30 km/h.
Total load-carrying capacity of double
tires should not exceed single tire load-
carrying capacity by not more than 1.7
times.
4. Adding weight to tires by filling tractor
tires with solution should be used only in
case of insufficient wheels traction with
soil under unfavorable conditions (over
humid soil, etc.). If wheels traction is
satisfactory, tires filling is not
recommended due to overloading of
transmission and operation tractor
mounting equipment.
Under no
circumstances fill tires to the full, as their
carcass may break when running over an
obstacle.
Maximum allowable load on tractor axle*, kN*,
Maximum allowable operation tractor
mass, kN (kg)
front
rear
70 (7140)
BELARUS 1025
24
53
BELARUS 1025.2
38
53
BELARUS 1025.3
38
53
* If by results of weighting and additional ballasting load values exceed allowable, ganging up
of such machines is forbidden.
Summary of Contents for 1025 2008
Page 205: ......
