Belarus 1025/1025.2/1025.3
Section E.Preparation for operation
E14
With PTO synchronous drive switched
on, tractor movement speed should not
exceed 8 km/h;
f) switch off PTO during assembly turns
(for trailing machines), as well as when
lifting the machine in transport position
(for mounting and half-mounting
machines);
g) after uncoupling the machine from the
tractor take gimbal drive joint off the
PTO drive end;
h) when on the rear PTO cover a driving
pulley, and drive reduction gears for
driving special machinery (cotton
harvester, excavators, etc.) are
installed, be sure to center them
against the drive end (put in the bore of
Ø162 mm on the rear cover), and
properly tighten their fastening nuts.
When operating rotational machinery for
tilling soil:
a)
control proper operation ability of
safety devices;
b)
do not switch PTO on when an
implement is lowered on the
ground;
c)
lower machines with rotating tools
smoothly during tractor movement;
d)
do not switch on PTO when
refraction angle of one of gimbal
drive joints exceed 35 degrees;
e)
when operating on hard soils start
with lateral strips tillage to get
access to the plot, and only then
proceed with longitudinal field
tillage.
IMPORTANT!
To exclude impact loads
on PTO reduce diesel speed to about
900 rev/min with PTO switched on,
then increase diesel speed. In a similar
way to reduce PTO brake belts loads
first reduce PTO speed by diesel
deceleration before PTO switching on.
It is of prime importance for
implements with high inertia moment.
Such tools should always be equipped
with free wheel clutch.
Operating trailers and trailing
machines
One-axle machines like half-trailers are
coupled with trailers by means of TCM-2
(hydraulic hook), and trailers by way of
TCM-3V* (automatic hitch towing
device). Transportation of machines by
means of TCM-1J (cross-piece) is
allowed only at speed of up to 15 km/h
without entering public roads, and
agricultural operations.
ATTENTION!
Do not gang up machines
like trailers and half-trailers via TCM-3J
(cross-piece).
Connect pneumatic system heads of a
trailer with no pressure in the tractor
hydraulic system.
When operating one-axle trailing
machines put additional loads to
upload tractor front axle.
Two-axle trailers are hitched to tractor by
way of TCM-3V (hitching with yoke TCM-
1J is not allowed). After tractor is hitched
to trailer make sure the fixing element is
fully out of housing, couple trailer with
tractor by means of safety chain (steel
rope).
Summary of Contents for 1025 2008
Page 205: ......