Belarus 1025/1025.2/1025.3
Section D. Controls and instruments
D21
Control of hydraulic hook interlock
(1).
Handle (1) has two positions:
•
The hook is down – upper position;
•
The hook is fixed – lower position.
To lower the hydraulic hook push
mounting unit levers to topmost position,
pull handle (1) up and put it on the catch,
then lower mounting unit levers.
To fix the hook raise mounting unit
levers to topmost position, take off
handle (1) from the catch and move it
lowermost position.
Switching on the rear power-take-off
shaft
Lever (1) has 2 positions:
•
«PTO is on» — topmost position,
•
«PTO is off» — lowermost position.
Important!
Use PTO synchronous
drive only at lower GB gears and
tractor travel speed of 8 km/h at the
outmost. Otherwise serious damage of
power gear may result.
Stand
alone and
synchronous PTO drives
Lever (2) has three positions:
•
«Standalone drive is on»
—
rightmost position;
•
«Synchronous drive is on» —
leftmost position;
•
«Off» — middle position.
Switch on PTO synchronous drive only
at lower gears and minimum diesel idle
run revolutions, having performed the
following operations:
•
start the diesel and set minimum idle
run revolutions;
•
push clutch pedal to the full and put in
the first or second gear;
•
slowly release the clutch pedal and at
the same time shift lever (2) to
leftmost position.
Summary of Contents for 1025 2008
Page 205: ......
