Belarus 1025/1025.2/1025.3
Section E. Preparation for operation
Operation of tractor equipped with HMU
with hydraulic lift
Unlike described above SAC with
standalone power regulators and power
cylinder, HMU with hydraulic lift is
controlled by two handles, located in the
cabin on the right-hand control panel.
•
Handle (2) of power control;
•
Handle (3) of position control.
E
11
Position control
1. Set handle (2) of power control to front
most position as tractor moves.
2. Using handle (3) of position control,
set needed height of an implement
above soil.
Figure «1» on the panel corresponds to
RMU transport position, and figure “9”
corresponds to minimum height of an
implement above soil.
If maximum lifting height should be limited
(for example, due to possible breakage of
rear PTO parts), use handle (3) to set
maximum lifting height and bring close to
it the adjustable stop (1).
Power control
Use this control method when operating
mounting implements (ploughs,
cultivators). Shift handle (2) of power
control to front most position as tractor
moves (figure «9» on the panel.
Using position control handle (3) connect
an implement to RMU.
After entering furrow, shift handle (3) to
front most position, and using handle (2)
adjust required depth of soil tillage.
When running out and subsequent
entering the furrow (during plough), use
only position control handle (3), not
touching power control handle (2).
If due to irregular soil density, constancy
of soil tillage depth can not be achieved,
limit maximum depth using position
control handle (3), and memorize relative
figure on the control panel.
Summary of Contents for 1025 2008
Page 205: ......
