Belarus 1025/1025.2/1025.3
Section E. Preparation for operation
E4
2.
Diesel is equipped with
incandescent plugs.
•
Perform operations 1 - 10 from
section "The order of diesel start".
•
Keep the key in position “I” for more
than 2 seconds. In this case easy start
control lamp lights to indicate switching
on of incandescent plug. Keep the key in
this position . As soon as control lamp
starts flashing, diesel is ready for start.
•
Turn key of starter switch to position
“II” and make start as shown above for
diesel start under normal conditions.
After diesel start control lamp goes down
and sound alarm is switched off.
•
Perform operations 12 and 13 from
section "The order of diesel start”.
If the control lamp lights in the
interrupted mode with frequency of 2
Hz after diesel start for 3 minutes, it
means that terminals of incandescent
plugs relay are wrong.
Shut down the diesel, disconnect
ground switch and correct malfunction.
.
Starting off and movement of tractor
Note:
When selecting required
movement speed, use the table of
movement speed, given in section “C”
•
Disengage the parking brake,
smoothly release the clutch pedal
and increase diesel rotation speed,
the tractor will start movement.
To put tractor in motion do the
following:
•
Decelerate the diesel.
•
Press clutch pedal to the full.
•
Select required GB range:
- Shift lever (1) to the extreme right
(spring-loaded) position, and pull or
push it to select I (lower) or II
(higher) mode, correspondingly;
- Return lever back to neutral position
(«N») and then further to the left to
select required range in
accordance with shifting diagram I.
•
Using lever (2) select required speed
in accordance with shifting diagram II.
ATTENTION!
Always press pedal clutch
before putting on required range or gear
of GB.
Summary of Contents for 1025 2008
Page 205: ......