Belarus 1025/1025.2/1025.3
Section F. Ganging up
F11
Machines, tools, can be mounted on the
tractor also by means of automatic hitch
SA-1, coupled to the tractor mounting
mechanism in three points (two rear joints
of lower tie-rods and rear joint of upper
tie-rod).
To prevent from accidental spontaneous
de-coupling of the machine from the
tractor secure the automatic hitch latch
with spring cotter-pin.
Limiting (telescopic) ties (1)
Ties are used for limiting lateral swinging
of the mounting lower tie-rods both in
transport and operational positions. It is of
particular importance when operating on
slopes, close to excavations, walls, etc.
Rear end of the tie is coupled to lower
tie-rod, and the front end – to the arm in
one of the four positions depending on
operation type:
•
Position 1. Ties exclude lateral
swinging of an implement in transport
position.
•
Position 2. Ties exclude lateral
swinging of an implement both in transport
and operational positions.
IMPORTANT!
Positions 3 and 4 should
be used only when lower tie-rods are
mounted on additional suspension axles
(upper axles).
•
Position 3. Ties exclude lateral
swinging of an implement in transport
position.
•
Position 4. Ties exclude lateral
swinging of an implement both in
transport and operational positions.
ATTENTION!
Ties should be installed
only in the second lowest openings of
arms (position 2) to avoid ties breakage.
Summary of Contents for 1025 2008
Page 205: ......
