Form No. 3385-268 Rev A
Air Ride Seat Suspension Kit
Reelmaster
®
5010 Series Traction Unit
Model No. 03667
Installation Instructions
Installation
1.
Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking brake
and remove the key from the ignition.
2.
Disconnect the negative battery cable from the battery.
3.
Disconnect the seat switch wire from the harness at
the rear of the control arm.
4.
Remove the (2) adjusting bolts securing the control
arm to seat mount (Figure 1). Carefully set the control
arm aside.
Note:
Make sure not to damage the wire harness or
the throttle cable.
1
g026049
2
Figure 1
1.
Control arm adjusting bolts
(2)
2.
Control arm access panel
5.
Remove the (4) nuts securing the seat adjusters and the
manual tube clamps to the seat suspension (Figure 2).
Also, remove the (4) washers between the seat adjusters
and seat suspension. Carefully set the seat assembly
aside.
6.
Remove the (4) bolts, spacers and nuts securing the
lower seat brackets to the seat base (Figure 2). Remove
the seat suspension and seat brackets from the seat
base. Use caution not to misplace the spacers during
removal.
7.
Remove the (4) bolts securing the seat suspension to
the lower seat brackets (Figure 2). Retain the bolts and
brackets for reuse.
Note:
When assembling the seat components, use the
front
mounting holes in the seat and the
rear
mounting
holes in the suspension.
8.
Secure the air ride seat suspension to the lower seat
brackets with the (4) bolts previously removed (Figure
2).
Figure 2
1.
Seat assembly
5.
Seat base
2.
Washer (4)
6.
Spacer
3.
Seat suspension
7.
Lower seat brackets
4.
Manual tube R–clamp (2)
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
*3385-268* A
