Baroness TDA1200, Service Manual

Page: 60 / 89

Drive the bearing by using a driver and
install the stop rings to both sides of it.
Push the urethane collar into the bearing.
1
3
2
pue9kj-017
Inspection of spring box_018
1 Bearing
2 Stop ring
3 Urethane collar
Install the box fixing collars into both sides
of the spring box.
1
pue9kj-018
Inspection of spring box_019
1 Box fixing collar
23.
24.
25.
Crank Assy
Inspection of crank Assy
Wear of bearings due to frequent usage and
invasion of water may damage bearings etc.
and prevent smooth rotation of the roller.
Inspect and replace the parts such as the
bearings.
Confirm that there is no crack in the upper
housing, crank bracket, and crank bracket
A.
Make sure that there is no wear or damage
of the drive shaft nor crank shaft.
Make sure that there is no wear or rust of
the bearing.
Make sure that there is no play in the fit of
the shaft and the bearing.
Confirm that there is no play in the upper
housing nor bearing.
Confirm that there is no play in the crank
bracket, crank bracket, nor drive shaft.
Remove the crank Assy from the machine.
See "Removal of crank Assy" (Page 4-11) .
Remove the cotter pin from the cotter pin
from the slotted nut, and then the slotted
nut and disc spring.
See "Crank Assy layout" (Page 4-10) .
2
1
ogzg3t-001
Inspection of crank Assy_001
1 Crank Assy
2 Slotted nut and disc spring
･
･
･
･
･
･
1.
2.
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-38
Inspection and repair of each section