Baroness TDA1200, Service Manual

Page: 31 / 89

Loosen the rope and lower the lower
housing Assy slowly.
2
3
1
mgo9ef-006
Removal of lower housing Assy_006
1 Bolt, washer, and nut
2 Rope
3 Lower housing Assy
Caution
The lower housing Assy is heavy.
Handle them carefully, since they could pinch
your hand.
Remove the bolts, washers, and spring
washers which are securing the lower
housing Assy, and remove the lower
housing Assy.
1
2
mgo9ef-007
Removal of lower housing Assy_007
1 Lower housing Assy
2 Bolt, washer, and spring washer
When removing the lower housing Assy
after that, attach the sling to the crank
housing at the highest point after setting the
lower housing Assy to be removed at the
lowest point, and follow the same
procedure.
[4]
[5]
4.
Installation of lower housing Assy
Caution
Refer to "Tightening torques" (Page 3-4) .
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
For installation, reverse the removing
procedure.
Spring box
Removal of spring box
Warning
When removing or installing any crank parts,
be sure to secure the crank.
If the crank is not secured, the crank may
become unbalanced and rotate suddenly.
It may cause injury or death.
The machine is removed from the tractor
with its upper link, up-down handle, and
cover removed.
Attach the sling to the crank housing at the
highest point after setting the spring box to
be removed at the lowest point.
Caution
The purpose is not to lift the main body. Do
not lift it up any more after the crank is
secured.
Lift the sling up by using a hoist, etc., to the
extent that the main body does not lift off
from the ground and then secure the crank
housing.
1
2
mgo9ef-001
Removal of spring box_001
1 Sling
2 Crank housing
･
1.
2.
Operating Machine and Mower Units
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-9
Removal and installation of each section