Baroness TDA1200, Service Manual

Page: 53 / 89

1 Bearing collar
2 Arm axis
3 Lock plate
Fasten the lower housing A on a vice, and
then remove its bearing.
Follow the same steps to remove a
bearing from the other side.
1
2
iiprkx-011
TDA1600_011
1 Lower housing A
2 Bearing
Caution
"Tightening torques" (Page 3-4) See the list.
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
Important
Be sure to replace the bearings, disc springs
and U nuts with new ones.
Install the lock plate on the arm axis.
Important
Install the bearing collars with taking care of
their correct directions.
13.
14.
15.
Insert bearing collars in each arm axis.
UP
4
1
3
2
iiprkx-012
TDA1600_012
1 Lock plate
2 Arm axis
3 Bearing collar
4 Top view of bearing collar
Drive a bearing into the arm axis which
has been fixed on the lock plate by using a
driver tool.
2
1
iiprkx-013
TDA1600_013
1 Bearing
2 Driver
Drive the lower housing B by using a
driver tool, and then insert its collar.
1
2
iiprkx-014
TDA1600_014
1 Lower housing B
2 Collar
16.
17.
18.
Operating Machine and Mower Units
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-31
Inspection and repair of each section