Baroness TDA1200, Service Manual

Page: 72 / 89

Use a bearing puller to remove bearing
from drive shaft C as pictured.
2
1
5s6or7-057
Inspection of gear box_028
1 Drive shaft C
2 Bearing
Important
Be very careful not to damage the 30-tooth
bevel gear. Especially the bladed side.
Use a bearing puller to remove bearing
from drive shaft C.
2
1
5s6or7-058
Inspection of gear box_029
1 Drive shaft C
2 Bearing
26.
27.
Prepare a pipe that fits in marked red
area on bevel, and make sure it has no
contact with the teeth or blades.
Apply 2 M20 washers to threaded side of
drive shaft C and fasten M20 nut.
[This is to protect the threaded portion of
drive shaft C]
To remove 30-tooth bevel gear from pipe,
place drive shaft C Assy in pipe making
sure not to touch the blades on the bevel.
Use wood hammer and hammer shaft
until 30-tooth bevel gear and drive shaft
C are separated.
2
1
5s6or7-059
Inspection of gear box_030
6
5
4
1
3
5s6or7-060
Inspection of gear box_031
1 30-toth bevel gear
2 Pipe's point of contact
3 Pipe [thickness 7 mm <]
4 Drive shaft C
5
Washer (TDA1200 use M20, TDA1600
use M24)
6
Nut (TDA1200 use M20, TDA1600 use
M24)
28.
[1]
[2]
[3]
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-50
Inspection and repair of each section