Baroness TDA1200, Service Manual

Page: 62 / 89

Knock the crank shaft by using a wooden
hammer to pull it out up to the crank
bracket face.
2
1
3
ogzg3t-007
Inspection of crank Assy_007
1 Vise
2 Crank shaft
3 Crank bracket face
Secure the upper housing on a vise and
remove the crank shaft by using a copper
bar, etc. in a way that its threaded part will
not be damaged.
1
2
ogzg3t-008
Inspection of crank Assy_008
1 Upper housing
2 Crank shaft
Secure the upper housing on the vise and
remove the bearing and collar.
1
2
ogzg3t-009
Inspection of crank Assy_009
12.
13.
14.
1 Upper housing
2 Bearing and collar
Important
Be sure to replace the bearings, disc springs
and cotter pins with new ones.
Important
The drive shaft has a specific installation
direction.
Confirm its direction.
Important
There are two types of crank shafts.
Confirm their installation positions.
Insert crank shaft A from the side with the
locking part of crank bracket A.
1
2
ogzg3t-010
Inspection of crank Assy_010
1 Crank bracket A
2 Crank shaft A
Drive in the bearing by using a driver.
1
ogzg3t-011
Inspection of crank Assy_011
1 Bearing
15.
16.
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-40
Inspection and repair of each section