Baroness TDA1200, Service Manual

Page: 79 / 89

Important
When installing drive shaft A do not scratch
crank gearbox A. Gently slide through oil seal
to avoid tearing or damaging.
Attach bearing to drive shaft A.
Carefully slide drive shaft A into lower
hole of crank gearbox B, through
previously installed bearing and out
through oil seal.
2
1
3
5s6or7-084
Inspection of gear box_057
1 Drive shaft A
2 Bearing
3 Crank gearbox B
Use driving tool to seat bearing in place.
1
5s6or7-085
Inspection of gear box_058
1 Bearing
53.
[1]
[2]
54.
Install stop ring. Make sure stop ring is
positioned correctly and fully sitting in
groove. Flat side of stop ring should be
facing away from bearing.
1
5s6or7-086
Inspection of gear box_059
1 Stop ring
With the flat-side of the stop ring facing
towards the pictured bearing, install stop
ring in groove on drive shaft B.
2
1
5s6or7-087
Inspection of gear box_060
1 Drive shaft B
2 Stop ring
Install 2-shaft 16-tooth gear as pictured
onto drive shaft B.
1
5s6or7-088
Inspection of gear box_061
1 2-shaft 16-tooth gear
55.
56.
57.
Operating Machine and Mower Units
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-57
Inspection and repair of each section