Baroness TDA1200, Service Manual

Page: 66 / 89

Gearbox
Gear box layout
2 2 3
1 1
dykztf-001
Gear box layout_001
1
Slotted nut 20 and cotter pin for drive
shaft
2
Slotted nut 24 and cotter pin for crank
shaft
3 Gearbox
Inspection of gear box
According to frequency of use, the bearings,
bevel gear, gear and etc. can become worn
and damaged. If the gearbox does not
operate smoothly check and inspect bearings,
bevel gear, gear and other parts for wear,
cracks or damage and replace where
necessary.
Check for cracks on the gearbox.
Check bearing for wear and rust.
Check bevel gear for wear, cracking or
chipping.
On drive shafts A and B, check splines for
wear, cracks and scratches.
Check that there is no wear in the key
grooves on drive shaft C.
Check there is no abnormality in both keys.
Check the wear on each stop ring.
Do not re-use spring pin, O-ring, oil seal
and seal washer, replace with new ones.
Important
Always replace spring pin, O-ring, oil seal and
seal washers with new ones.
･
･
･
･
･
･
･
･
Remove 14 plug and 14 seal washer from
gear box and drain oil.
1
2
5s6or7-030
Inspection of gear box_001
1 Gearbox
2 14 plug, 14 seal washer
Make sure the change lever is in the low
position.
2
A
1
5s6or7-031
Inspection of gear box_002
1 Change lever
2 Shift fork
A Shift position (LOW speed)
Remove U nut and washer from 2 places
on the shift lever. At shift fork, remove bolt,
compression spring A and washers. At the
bottom of the change lever remove bolt and
washer.
1
2
3
4
5
6
5s6or7-032
Inspection of gear box_003
1.
2.
3.
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-44
Inspection and repair of each section