B&R Automation PC 620, User Manual

Page: 286 / 594

286
Software • BIOS options
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
Secondary IDE
Slave The drive in the system that is connected
to the IDE secondary slave port is
configured here. Enter Opens the submenu
Third IDE Master
3)
The drive in the system that is connected
to the IDE third master port is configured
here. Enter Opens the submenu
Third IDE Slave
4)
The drive in the system that is connected
to the IDE third slave port is configured
here. Enter Opens the submenu
Hard disk write
protect Write protection for the hard drive can be
enabled/disabled here. Disabled Disables this function.
Enabled Enables this function.
PATA Detect Time
Out (Sec) Configuring the time overrun limit value for
the PATA device identification. 0, 5, 10, 15, 20, 25, 30,
35
Value set manually.
SATA Detect Time
Out (Sec) Configuring the time overrun limit value for
the SATA device identification. 0, 1, 2, 3, 5, 10, 15, 30 Value set manually.
ATA(PI) 80Pin Cable
Detection Detects whether an 80 pin cable is
connected to the drive, the controller or to
both.
Information:
This option is not available on the
APC620 CPU board. Therefore this
setting is not relevant.
Host & device Using both IDE controllers (motherboard, disk
drive).
Host IDE controller motherboard used.
Device IDE disk drive controller used.
1) These settings are only possible if ATA/IDE Configuration is set to Compatible or Enhanced .
2) If this setting is enabled and ATA/IDE Configuration is set to Compatible , then only the submenus Primary IDE Master and Primary IDE
Slave will be shown.
3) This submenu is only open if ATA/IDE Configuration is set to Enhanced .
4) This submenu is only open if ATA/IDE Configuration is set to Enhanced .
BIOS setting Meaning Setting options Effect
Table 179: X945 Advanced IDE Configuration setting options