B&R Automation PC 620, User Manual

Page: 251 / 594

Commissioning • Connection examples
Section 3
Com
m
is
sio
ning
251 Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
The cable types and resolutions shown with a footnote 2) in the previous table can only be
implemented starting with the following firmware and hardware versions:
4.10.4 BIOS settings
No special BIOS settings are necessary for operation without touch.
To operate Automation Panel 900 panels with a touch screen (Extended Desktop or Dual
Display Clone), the serial interfaces COM C and COM D must be activated in BIOS (BIOS default
setting = disabled).
4.10.5 Windows graphics driver settings
See chapter 4 "Software", section 6 "Automation PC 620 with Windows XP Professional", on
page 351.
If all connected Automation Panel 900 panels and Automation Panel 800 panels (line 1 + line
2) should display the same content, then "Dual Display Clone" mode must be set in the graphics
driver (see chapter 4 "Software", section 6.2.3 "Graphics settings for Dual Display Clone", on
page 357).
4.10.6 Windows touch screen driver settings
See chapter 4 "Software", section 6 "Automation PC 620 with Windows XP Professional", on
page 351.
Firmware Name Version Note
MTCX FPGA Firmware on the APC620 v 01.15 The version is read from BIOS - see the BIOS
description.
Supported starting with the APC620 / PPC 700
Firmware upgrade (MTCX, SDLR, SDLT) V01.10 ,
available in the download area of the B&R
homepage.
MTCX PX32 Firmware on the APC620 v 01.55
Hardware Name Revision Note
5PC600.SX01-00 System 1 PCI Rev. E0 -
5PC600.SX02-00 System 2 PCI, 1 disk drive slot, 1 AP Link slot Rev. D0 -
5PC600.SX02-01 System 2 PCI, 1 disk drive slot Rev. E0 -
5PC600.SF03-00 System 3 PCI, 1 disk drive slot, 1 AP Link slot Rev. A0 -
5PC600.SX05-00 System 5 PCI, 2 disk drive slots, 1 AP Link slot Rev. C0 -
5PC600.SX05-01 System 5 PCI, 2 disk drive slots Rev. C0 -
Table 163: Requirements for SDL cable with extender and automatic cable adjustment (equalizer)