B&R Automation PC 620, User Manual

Page: 229 / 594

Commissioning • Connection examples
Section 3
Com
m
is
sio
ning
229 Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
The cable types and resolutions shown with a footnote 2) in the previous table can only be
implemented starting with the following firmware and hardware versions:
4.5.3 BIOS settings
No special BIOS settings are necessary for operation.
4.5.4 Windows graphics driver settings
"Digital display" must be defined as output device in the graphics driver.
For more information on this, see chapter 4 "Software", section 6 "Automation PC 620 with
Windows XP Professional", on page 351.
4.5.5 Windows touch screen driver settings
For more information on this, see chapter 4 "Software", section 6 "Automation PC 620 with
Windows XP Professional", on page 351.
Firmware Name Version Note
MTCX FPGA Firmware on the APC620 v 01.15 The version is read from BIOS - see the BIOS
description.
Supported starting with the APC620 / PPC 700
Firmware upgrade (MTCX, SDLR, SDLT) V01.10 ,
available in the download area of the B&R
homepage.
MTCX PX32 Firmware on the APC620 v 01.55
Hardware Name Revision Note
5PC600.SX01-00 System 1 PCI Rev. E0 -
5PC600.SX02-00 System 2 PCI, 1 disk drive slot, 1 AP Link slot Rev. D0 -
5PC600.SX02-01 System 2 PCI, 1 disk drive slot Rev. E0 -
5PC600.SF03-00 System 3 PCI, 1 disk drive slot, 1 AP Link slot Rev. A0
5PC600.SX05-00 System 5 PCI, 2 disk drive slots, 1 AP Link slot Rev. C0 -
5PC600.SX05-01 System 5 PCI, 2 disk drive slots Rev. C0 -
Table 134: Requirements for SDL cable with extender and automatic cable adjustment (equalizer)