Software • B&R Automation Device Interface (ADI) driver - Control Center
Section 4
Soft
w
are
377
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
10.4.1 Installing the UPS service for the B&R APC add-on UPS
1) Open the
Control Center
in the
Control Panel
.
2) Select
UPS
tab.
3) Click on
System
under
UPS settings
. This opens the
Power Options
in the
Control Panel
.
(The
Power Options
can also be opened directly from the
Control Panel
.)
4) Select the
UPS
tab and click
Select...
.
5) Choose 'Ber Rainer' as manufacturer and 'APC Add-On UPS' as model and then
click
Finish
. The value for the COM connection is only required for a serially connected UPS
and is ignored by the APC add-on UPS driver.
6) Click on
Apply
to begin UPS operation. After a few seconds the UPS status and details are
displayed.
Figure 174: ADI Control Center - UPS settings
Caution!
The installed UPS must be selected and configured in the Control Panel using the
energy options in order for battery operation to be supported.
Information for Windows XP Embedded:
The UPS service is supported starting with B&R Windows Embedded Version 2.10
or higher.
Summary of Contents for Automation PC 620
Page 2: ...2 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 4: ...4 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 6: ...6 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 568: ...568 Appendix A Glossary Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...