B&R Industries Automation PC 620, User Manual

Page: 323 / 512

Software • Automation PC 620 with BIOS
Chap
ter 4
•
Soft
w
are
323 Automation PC 620 User's Manual V 1.90
1.5.4 Upgrade BIOS for 855GME
• Download and unzip the zip file from the B&R homepage.
• Copy the files to a MS-DOS startup disk or USB flash drive (see Section 1.5.7 "Creating
a DOS boot diskette in Windows XP" on page 329 for information about creating a
bootable disk or Appendix A, Section "Creating a bootable USB flash drive" on page 420
about creating a bootable USB Memory stick).
• Insert the diskette in the USB floppy drive or the USB flash drive in the USB port and
reboot the APC620.
• The following boot menu will be shown after startup
1. Upgrade PHOENIX BIOS for 855GME
2. Exit
Concerning point 1:
BIOS is automatically upgraded (default after 5 seconds).
Concerning point 2:
Return to the shell (MS-DOS).
• The system must be rebooted after a successful upgrade.
Profile 3 Panel PC 700 system unit 5PC720.1043-00,
5PC720.1214-00, 5PC720.1505-00,
5PC781.1043-00, 5PC781.1505-00 and
5PC782.1043-00. On On Off Off Off Off - -
Profile 4 Panel PC 700 system unit 5PC720.1043-01,
5PC720.1505-01 and 5PC720.1505-02. Off Off On Off Off Off - -
1) Not required. Free.
Information:
When the system has rebooted, setup default values must be reloaded after the
message, "
System CMOS checksum bad
" (press F1 or select "load setup defaults"
in the BIOS setup "exit" menu).
Starting with BIOS version V1.15, the time and date no longer has to be set again
after a BIOS upgrade (stays the same).
Number Optimized for device
DIP switch setting
1 2 3 4 5 6 7
1)
8
1)
Table 236: Profile overview (cont.)