Axel WOLF 1MS, User Manual, Page: 75 / 229

| 75
It is possible to set for each single parameter under control the Masked or unmasked and the Severity Level on these
value:
RFL2
–
RFL1 / RFH1
–
RFH2
–
DEV
–
PILOT Low
– PILOT – RDS Low – RDS – AUDIO Dev - AUDIO Left – AUDIO
Right
–AUDIO Ms - AUDIO Si - PI –
PS
–
TP - TA
–
CT
–
RT
–
AF
–
EON
– IH -
TMC
–
RT+ - ODA1
–
ODA2
–
BLER
in the column MASK .
14.6.7
The meaning of “Mask” on each single parameter under control
On each single parameter under control it is also possible to set the if the single parameter can be Masked, unmasked,
Severity1
– Severity2 – Severity3 or RFL2. In this case each single parameter follow an Individual Masking.
The severity level is generally assigned in order to have a relation between the parameter under control and the priority.
All the parameters involved in Severity1
– Severity2 – Severity3 can be masked or not.
Masked
Alarm
IS masked (if Global Tuner Mask Mode is set in individual masking)
Unmasked
Alarm
IS NOT masked (if Global Tuner Mask Mode is set in individual masking)
Severity-1
The Alarm is masked only if
Global Tuner Mask Mode is set on a Severity < or equal
to 1 (it means always not masked)
Severity-2
The Alarm is masked only if
Global Tuner Mask Mode is set on a Severity < or equal
to 2
Severity-3
The Alarm is masked only if
Global Tuner Mask Mode is set on a Severity < or equal
to 3 (it means always masked)
RFL2 Mask
Masked if the Alarm RFL2 Mask is active.
(see Note2 below)
Note1 : it is not possible to mix the ( Severity1 - Severity2 - Severity3 ) with Individual Masking
Note2 : in order to work properly the RFL2 Mask requires that validation is less of RFL2 and Hold time is greater than the
individual alarms that use this type of mask.