Axel WOLF 1MS, User Manual, Page: 206 / 229

TECHNICAL APPENDIX
| TECHNICAL APPENDIX 206
If a valid (no alarm) condition is found in this time, system unlocks and normal scan reprises.
If no valid condition is found, system unlocks, normal scan reprises and an alarm condition and/or a trap is reported (see
above).
Note that Channel Memory reports normal index display (“1 of 3”).
If alarm condition persists, after a while the system stops again on channel and the procedure restarts (note that now the
alarm condition status ON persists).
The traps will be sent in the instant the alarm rises up, but IH and the time in the var-binds will be related to the first failed
check.
Under the alarm condition the RDS alarm led on the panel must be on (flashing if the alarms are more than one on the
channel list) and clicking on the channel number of the correspondent tuner the RDS error w
ill be displayed (“RDS
DATA”).
In case of more errors on the related channel, they will rotate for about 30 seconds in a sequence carousel.
REPLAY ENABLED TRAPS
The Rds IH alarm trap are replayed with its original status, time and value. Trap Counter is normally incremented.
All data and parameters are available in the MIB L3-5 to set and test this configuration.