AvL Proprietary and Confidential
Content is Subject to Change without Notice
Page
120
of
195
Current Satellite
should be set to the Longitude value of the Target Satellite. Format is important
for this parameter. It must be entered in decimal degrees followed by a space and a single letter
indicating hemisphere (e.g. 61.5 W or 110.0 E).
Reference Satellite
Mode
performs two checks to determine if either Reference Profile is valid for
use in locating the Target Satellite. The first check looks to see if either Reference Satellite is within
the SatTant Min Long dif (typically 20 degrees) Core Configuration setting available for reading and
writing at level 7 and above. The second check looks to see that the elevation of the Reference
Satellite is greater than zero degrees. If both Reference Satellites are valid, then the closest is used
for reference. If both Reference Satellites fail, then the AAQ performs a SatTant to locate the
Target Satellite.
The
Current Satellite Longitude
parameter is the longitude of the satellite to target during acquire
with the numeric portion in decimal degrees and the hemisphere as a single letter (ie 61.5 W)
The
Current Satellite NORAD ID
parameter is the NORAD ID of the Satellite, Used For Target
Updates
The
Current Satellite Polarization
parameter is the Feed polarization for the selected satellite
The
Current Satellite TLE Line 1
parameter is Line 1 of the NORAD Two Line Ephemeris
The
Current Satellite TLE Line 2
parameter is Line 2 of the NORAD Two Line Ephemeris
The
Run Repeak on Startup
parameter is the flag indicating whether the repeak command should
be run on startup if Rx is locked
The
Run Track After Acquire
parameter is the flag indicating that the Track Command should run
after a successful peak command
The
Run Track After Peak
parameter is the fag indicating that the Track Command should run after a
successful acquisition
The
Run Track on Startup
parameter is the flag indicating that the Track Command should run on
startup
The
Tracking Method
parameter is the Tracking Method to use after an Acquisition has been
completed
The
Update Heading After Acquisition
parameter is the flag indicating that the Heading should be
recalculated after an acquisition is completed.
