AvL Proprietary and Confidential
Content is Subject to Change without Notice
Page
114
of
195
The “Fast” setting is typically set to a value at or above the maximum speed that the antenna axis
can move. Setting a value higher than the maximum actual speed has no effect, ill or otherwise.
Common values are in the area of 1 to 6 degrees per second.
The “Slow” setting is typically set to a very low value. This allows very fine adjustments to be made
such that accurate fine peaking on that axis can be easily verified or emulated. Common values are
in the area of 0.1 to 2 degrees per second.
Manual Control Allow Modem Tx
.
makes transmitting from modem possible in manual mode.
Typically this is not recommended, given the possibility of unintended interference and should be
used with caution.
The
Step Mode Sample Delay
parameter is the delay in ms between testing and retrying the step jog
mode move.
6.3.4 Acquisition
Long name
Level
Type
Value Range
Documentation
Line Scan Polarization Adjust
Flag
4
Choice
"No", "Yes"
Flag indicating that the Pol should be adjusted during a
line scan. Usually set to Yes.
Compass Scan Width
1
Float
0.0 to 400.0 (deg)
Scan width to use during a SatTant or 0.0 to disable
SatTant.
GPS Scan Width
1
Float
0.0 - 400.0 (deg)
Scan width to use during a SatTant or 0.0 to disable
SatTant.
Manual Compass Scan Width
1
Float
0.0 to 360.0
Heading scan width in degrees to scan if override
compass is selected.
NoCompass Scan Width
1
Float
0.0 - 400.0 (deg)
Scan width to use during a SatTant or 0.0 to disable
SatTant.
Polarization Flip Amount
4
Float
-180 to 180
This will be added to pol when target is below CCW
limit & subtracted when above CW limit.
Polarization Home Position
4
Float
-180 to 180
Position in degrees of the pol home switch
Pitch Inc Offset
4
Float
-180 to 180
Offset in degrees to add to the pitch inclinometer
Roll Inc Offset
4
Float
-180 to 180
Offset in degrees to add to the roll inclinometer
Azimuth Motor Scale Factor
4
Integer
-100000 to 100000
Unit factor to divide by to produce the actual value
needed by code
Azimuth Motor Abs Enc Offset
4
Float
-600.0 to 600.0
The offset in degrees to be added to the read position
of the absolute encoder
Azimuth Motor Abs Enc Scale
Factor
4
Float
-10000.0 to 10000.0
The factor that will be multiplied to the raw absolute
encoder or resolver value
Elevation Motor Scale Factor
4
Integer
-100000 to 100000
Unit factor to divide by to produce the actual value
needed by code
Elevation Motor Abs Enc Offset
4
Float
-600.0 to 600.0
The offset in degrees to be added to the read position
of the absolute encoder
Elevation Motor Abs Enc Scale
Factor
4
Float
-10000.0 to 10000.0
The factor that will be multiplied to the raw absolute
encoder or resolver value
