MP-40x SIP MediaPack BRI Series
SIP User's Manual
48
Document #: LTRT-53301
Figure
4-13: Coder Groups Screen
2.
From the list of coder groups, select the coder group, and then define up to five
coders.
Note:
The preferred coder is the coder that the MediaPack uses as a first choice
for all connections. If the far-end gateway does not use this coder, the
MediaPack negotiates with the far-end gateway to select a coder that both
sides can use.
4.1.8
Configuring IP to Tel Routing Table
The IP to Tel Routing table is used to route incoming IP calls to the relevant ISDN
interface.
The procedure below describes how to configure IP-to-Tel call routing according to our
example setup: Incoming IP calls with destination number 1000 are to be routed to ISDN
interface number 0; while incoming IP calls with destination number 3000 are to be routed
to ISDN interface number 1.
¾
To route incoming IP calls to the relevant ISDN interface take the
next 2 steps:
1.
Open the ‘IP to Tel Routing Table’ screen (
Protocol Management
menu >
Routing
Tables
submenu >
IP to Tel Routing
option).
